JED T430 User Manual page 57

Set a projector code of 60 hex, and reset the T440 with the reset switch. Check the operation at 19200: (One red blink
then steady, On, Off, channels working OK) It is ready for use.
(If the projector needs to be reset to operate at 115200, set code 62 hex and reset the T40. The red OFF let will come on
steady. Press the/an ON button. The #CH<CR><LF> baud rate change command is sent to the projector.
Set code 63 hex and Reset the T440, and verify the projector operates ok at 115200 baud (One red blink then steady,
On, Off, channels working OK) The baud rate is held in projector non-volatile memory, so the baud rate setting to
19,200 need be done only once.
(Toshiba was here, covered with codes 56 and 57.)
th
T440 User's manual V096B, © JED Microprocessors Pty Ltd Jan 20 2015 Page 57