Smart Projector; D-Sub 9 Male Solder Side - JED T430 User Manual

Smart projector family, eg
Manuals are at:
SLR40wi:
http://smarttech.com/Support/Browse+Support/Product+Index/Hardware+Products/SMART+Interactive+Projectors/40
wi
UF75: http://smarttech.com/supportSB600i5
UF55/UF55w:
http://downloads01.smarttech.com/media/sitecore/en/support/product/smartboardsfpd/600i3sbd600i3series/guides/guide
sb_sbd600i3v25nov09.pdf
Channel codes are:
Input1 := 'set input=vga1' + 0D; //Computer 1: Input 1: DB15
Input2 := 'set input=vga2' + 0D; //Computer 2: Input 2: DB15
Input3 := 'set input=composite' + 0D; //Video1 ; //Video1 *OPT1 ON will use HDMI as Video 1
Input4 := 'set input=HDMI' + 0D; //Video2 HDMI (some only)
* T440: Setting OPT6 switch to ON will use S-Video in place of HDMI, and
Input4 := 'set input=s-video' + 0D; //Video2 S-video. T430: Uses HDMI for Video2
Input5 := 'set input=s-video' + 0D;
Input6 := 'set input=HDMI' + 0D;
Any one of these codes can be set into Constant:0/Constant:1 for computer codes and Constant:2/Constant:3 for video
codes. (The default is to have Computer1 (above) as the "Computer" channel and Video1 as the "Video" channel.
Setting OPT1 switch ON will swap Video1 and Video2 channels. Setting OPT5 switch ON will swap Computer 1 and
Computer 2 sources.)
Mute or Freeze functions are supported on SLR40wi and UF75 and UX60. Others not supported.
•
OPT7 handshake mode and power on panel connection blink codes available.
•
RS232 connections to Smart Projectors
These use a 9-pin-D9 male on the projector, male on cable. Communications is at 9600 baud 8N1.
Function/Direction
Ground
Data from T440 to projector
Reply data from projector to T440
Plus 9 volt CTS/DTR to projector
After installation wiring of any projector to a T440, use a multimeter to check voltages of –9 on BOTH TX and RX pins
in any installation, as described in the troubleshooting part of this manual.
T440 User's manual V096B, © JED Microprocessors Pty Ltd Jan 20
SLR40wi (code 7A), UF75, UX60, INIFI UF55/w,
UX60: http://smarttech.com/supportSB600ix
T440 "projector"
Connection
Ground
Tx
Rx
N/C
Smart "Control" Port
Connector
9-pin D-sub pin 5
9-pin D-sub pin 3 (RXD)
9-pin D-sub pin 2 (TXD)
N/C
th
2015
(Code 7B hex)
5 4 3 2 1
9 8 7 6
D-sub 9 male
solder side
Page 49