15. Note: If assembled on a smooth surface, the
treadmill may roll forward during this step.
Raise the Frame (56) to the upright position.
IMPORTANT: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 17 is completed.
Orient the Latch Crossbar (38) as shown. Make
sure that the "This side toward belt" sticker
(E) is facing the treadmill. Attach the Latch
Crossbar to the brackets on the Frame (56) with
two 5/16" x 3/4" Screws (25) and two 5/16" Star
Washers (11).
16. Orient the Storage Latch (53) so that the decals
are facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (53) to
the bracket on the Base (94) with a 5/16" x 1 3/4"
Bolt (6) and a 5/16" Nut (12).
Raise the Storage Latch (53) to a vertical posi-
tion. If there is a tie in the top of the Storage
Latch, remove and discard it.
15
11
25
56
16
Tie
Decals
12
16
Brackets
E
38
11
25
53
94
6
Need help?
Do you have a question about the Power 995i PFTL99513.0 and is the answer not in the manual?