Table of Contents
Advertisement
User define:
Allows user to define PM Timers parameters to control power saving
mode.
Video Off Method
This option allows you to select how the video will be disabled by the power
management. The default is V/H Sync + Blank
V/H Sync + Blank:
DPMS Support:
Blank Screen:
Suspend Mode
Automatically, shuts off all devices except the CPU after a preset period of system
inactivity.
Options: Disabled, 1 , 2, 4 ,6, 8, 10, 20, 30, 40 min and 1 hour .
HDD Power Down
Powers down the hard disk drive after a preset period of system inactivity.
Options: Disabled, 1 ~ 15 Min.
Soft-Off by PWR-BTTN
Use this to select your soft-off function. The default is Instant Off.
Instant Off:
Turns off the system instantly.
Delay 4 Second :
Turns off the system after a 4 second delay. If momentary press
of button, the system will go into Suspend Mode. To wake the
system, press the power button again.
Wake-Up by PCI Card
An input signal form PME on the PCI card awakens the system from soft-off state.
Options: Enabled, Disabled.
Resume By Alarm
When set to Enable alarm resume, you can set the date (of month) and time (hh:mm:
ss), that will awaken a system which has been powered down.
Options: Enabled, Disabled.
System turns off vertical and horizontal synchronization ports
and writes blanks to the video buffer.
Select this option if your monitor supports the Display Power
Management Signaling (DPMS) standard of the Video
Electronics Standards Association (VESA). Use the software
supplied for your video subsystem to select video power
management values.
System only writes blanks to the video buffer.
BIOS
Page 4-13
Advertisement
Table of Contents
