Table of Contents
Advertisement
Back Panel
TO WALL
(VIDEO IN)
1
1 To Wall (Video In)
2 To TV (Video Out)
3 Network
4 eSATA Port
5 YPbPr
6 S-Video
7 Video Out
8 Audio Out (L/R)
9 Optical
10 HDMI
11 USB Port
12 Power
Note: This illustration may vary from the actual product.
TO TV
(VIDEO OUT)
NETWORK
eSATA
2
3
4
Connect the receiver to in-house coaxial wiring, if applicable
Connect to TV. You must set the channel on your TV to the channel
designated by your service provider (usually channel 3). Contact your
service provider for the channel information
Connect to the Ethernet (CAT-5) network at your home, if applicable
eSATA connector. DVR unit only (Reserved for future use)
Connect the receiver to the component video input (YPbPr) on the
HDTV. See pages 12 and 13 for more information
Connect an S-Video cable to send an S-Video signal to your TV, VCR, or
DVD recorder. This signal is standard-defi nition but higher quality than
other standard-defi nition TV connections. See page 13 for more
information
Connect to composite input on your HDTV or SDTV
Note: Two video output connectors are provided. Typically, one output
is connected to the TV, and the other output is used to connect to a
home theater system, DVD recorder, or VCR
Connect RCA-type cables to Audio Out to send analog audio signals
(left and right) to a TV with stereo inputs or to a stereo amplifi er
Note: Two sets of audio out connectors are provided. Typically, one
set of outputs is connected to the TV, and the other set is used to
connect to a home theater system, DVD recorder, or VCR
Connect an optical cable to send a digital audio signal to a surround-
sound receiver or other digital audio device
Connect an HDTV HDMI
from the HDTV to the HDMI port. HDMI supports both digital audio and
video. See page 12 for more information
USB connector. (Reserved for future use)
Connect the DC output of the AC power adapter (provided) to deliver
power to the receiver
Pb
Y
L
Pr
VIDEO
AUDIO
S-VIDEO
OUT
OUT
5
6
7
8
™
(High-Defi nition Multimedia Interface) cable
R
OPTICAL
HDMI
USB
9
10
11 12
POWER
9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ISB7000 and is the answer not in the manual?
Questions and answers
How do I configure the ISB7500 DVR to record and play back from TV's in multiple rooms while connected via ethernet
The Cisco ISB7000 DVR is designed to use your in-home IP network for multi-room DVR functionality. To configure it for recording and playback on TVs in multiple rooms using Ethernet:
1. Connect the DVR to the Ethernet network: Plug an Ethernet (CAT-5) cable from your home network into the "Network" port on the back of the DVR.
2. Ensure all TVs are connected to the same network: Verify that all TVs you want to use for playback are connected to the same in-home IP network. This can be done through Ethernet or compatible network devices.
3. Activate Total Home DVR service: Contact your service provider to ensure the Total Home DVR service is activated. This service allows recording and playback on multiple TVs.
Once set up, you will be able to:
- Record shows on the DVR and play them back on any connected TV.
- Pause, fast-forward, and rewind recorded content from any room.
- Pause a recorded show in one room and resume it in another.
This answer is automatically generated