Settings Menu - InFocus LP 650 User Manual

Settings menu

Audio: allows adjustments to the sound Balance between speakers and
speaker Volume. The Internal speakers and projector startup Chime can be
turned on or off by placing or removing a check in the respective check-
boxes.
Sources>Power-up Source: this determines which source the projector
checks first for active video during power-up.
:
Sources allows you to assign a particular input to a specific source key as
an optional full-featured remote. Also allows selection of a default Power-
up Source and enables or disables Autosource.
When Autosource is not checked, the projector defaults to the source
selected in Power-up Source. If no source is found, a blank screen displays.
When Autosource is checked, Power-up Source determines which source
the projector defaults to at power-up. If no signal is present, the projector
checks the sources in order until a source is found or until power down.
>
System Rear: reverses the image so you can project from behind a translu-
cent screen.
Ceiling: turns the image upside down for ceiling-mounted projection.
Auto Power: When Auto Power is checked, the projector automatically
goes into the startup state after the projector is powered on. This allows con-
trol of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as "Searching" or
"Mute") in the lower-left corner of the screen.
Low Power: toggles between on and off. Turn it on to lower the light output
of the lamp. This also lowers the fan speed, making the projector quieter.
Power Save: automatically turns the lamp off after no signals are detected
for 20 minutes. After 10 additional minutes with no signal, the projector
powers down. If an active signal is received before the projector powers
down, the image will be displayed.
Source 1
33
Audio
Power-up
Sources
Source
System menu