Replacing The Projection Lamp - InFocus LP 650 User Manual

Replacing the projection lamp

The lamp hour timer in the About menu counts the number of hours the
lamp has been in use. After 1,480 hours, the message "Change lamp" briefly
appears on the screen at each startup. When the timer reaches 1,500 hours,
the lamp will no longer light. You can order new lamp modules from your
dealer. See "Accessories" on page 40 for information.
1 Turn off the projector and unplug the power cable.
2 Wait 60 minutes to allow the projector to cool thoroughly.
3 Turn the projector upside down and remove the lamp door by removing
the two screws and sliding the lamp door tabs out of the three tab bays.
CAUTION: Never operate the projector with the lamp door removed.
This disrupts the air flow and causes the projector to overheat.
4 Loosen the captive screw on the lamp module.
video
R
audio in Y
computer 1 computer 2 s-video monitor
network
R
audio in Pr
audio in L
computer in serial control
audio out
L
Pb
bail wire
37
About menu
turn off and unplug
the projector
wait 60 minutes
loosen the screw on lamp module