Pressure; Tire Sealing System* - Inflating Tires; Inflation Pressure - Volvo S60 Owner's Manual

09 Wheels and tires
09
CAUTION
If your vehicle is equipped with the Tire
Pressure Monitoring System (TPMS), the
use of the sealing compound may lead to
incorrect tire pressure readings or in rare
cases, damage to the tire pressure sensor.
Use the tire sealing system to check and
adjust the damaged tire's inflation pres-
sure.
NOTE
•
Safely stow the tire sealing system in a
convenient place as it will soon be
used again to check the tire's inflation

pressure.

•
The empty bottle of sealing compound
cannot be removed from the bottle
holder. Consult a trained and qualified
Volvo service technician to have the
bottle removed and properly disposed
of.
WARNING
If heavy vibrations, unsteady steering
behavior, or noises should occur while
driving, reduce speed and park the vehicle
in a safe place. Recheck the tire for
bumps, cracks, or other visible damage,
and recheck its inflation pressure. If the
pressure is below 19 psi (1.3 bar), do not
continue driving. Have the vehicle towed
to a trained and qualified Volvo service
technician.
*
312
Option/accessory, for more information, see Introduction.
Tire sealing system – checking

inflation pressure

The tire sealing system can also be used to
check the tires' inflation pressure.
Stage 2: Checking inflation pressure
1. Connect the tire sealing system as
described in stage 1, see Tire sealing
system* – sealing hole (p. 310).
2. Refer to the inflation pressure table in this
chapter for the correct inflation pressure.
If the tire needs to be inflated, start the
tire sealing system's compressor. If nec-
essary, release air from the tire by turning
the air release knob counterclockwise.
CAUTION
The compressor should not be used for
more than 10 minutes at a time to avoid
overheating.
WARNING
If you interrupt your trip for more than 1
hour, check the inflation pressure in the
damaged tire again before continuing.
Tire sealing system* – inflating tires
The tire sealing system can be used to inflate
the tires.
To do so:
1. Park the car in a safe place.
2. The compressor should be switched off.
Ensure that the on/off switch is in position
0 (the 0 side of the switch should be
pressed down).
3. Take out the electrical wire and hose.
4. Remove the valve cap from the tire's
inflation valve and screw the hose con-
nector onto the valve as tightly as possi-
ble by hand.
5. Connect the electrical wire to the nearest
12-volt socket in the vehicle.
6. Start the vehicle's engine.