Problem
When the oven is
switched on "System
lock 0" will appear in
the display.
The oven does not heat
up.
"Power cut - Process
cancelled" appears in
the display.
12:00 appears in the
display.
The message
"Maximum operating
duration reached"
appears unexpectedly
in the display.
"; Fault XX" appears in
the display.
Possible cause and remedy
The system lock 0 is active.
It can be released by pressing the OK sensor for at
least 6 seconds.
The system lock can be permanently deactivated (see
"Settings – System lock 0").
^ Check whether "On" has been selected for demo
mode (see "Settings - Showroom programme").
If demo mode has been switched on the oven can be
operated but it will not heat up.
^ Deactivate demo mode.
There has been a power cut which has caused a
current process to stop.
^ Switch the oven off and then back on again.
Start the cooking programme again.
The power supply was interrupted for longer than 200
hours.
^ Reset the time and date.
The oven has been operating for an unusually long time
and this has activated the safety switch-off function.
^ Select "OK". Touch # to delete "Process finished".
The oven will then be ready for use again.
There is a problem that you cannot resolve.
^ Call the Miele Service Department.
Problem solving guide
129