Table of Contents
Advertisement
4.3 GSM remote operation (talk-back function added)
When alarm occurs, GSM will call the preset voice number, when pick up
the call.enter 4 digit user code, then voice prompt: Press 1 to arm system,
Press 2 to disarm system, Press 3 to Stay arm, Press 4 lo check system
status, Press 5 to appliance switch control, Press 9 to talk-back, Press 0 to
Disconnect.
4.4 GSM alarm receiving (talk-back function added)
When alarm occurs, it will send SMS first, then call the preset voice number,
when pick up the call, ii will play the recorded voice message first, then voice
prompt: Press1 to cancel alarm, Press 2 to check alarm event, Press 3 to arm
system.Press 4 to disarm system, Press
5
lo Stay arm, Press
6
lo enable siren,
Press
7
to listen-in, Press
8
to control programmable output port, Press
9
to
talk-back, Press
0
to Disconnect.
4.5 GSM control via SMS
Arm command:
password:f234syslemarml
Disamrcommand: password:1234 system disarm
Slay command:
password:i234systemtlome
Cancel alarm command:
[pass,.,ord:123~systelTlcanc<!iJ
Status checking command:
I
password:1234 system status]
Enable programmable output port command:
lllaswoiiEf234pgmopen
I
Disable programmable output port command:. password:1234 pgm close.
Enable appliance switch command:
switch
Disable appliance switch command:
• password: 1234 switch close X(X=1-8 on behalf ofappliance switch number)•
Setapn: • password:1234 apn:"aaa·
Set ID:
cpassword:T234usero"l:il:>I:>"
Set password:
I
password:1234 pwd: "ccc"
Note: the factory default user code is 1234, when arm successfully, SMS auto
reply" arm successfully" , if the password is correct, the command is not
correct, SMS will reply" operation failure" , ifthe password is not correct,
no SMS reply.
Advertisement
Table of Contents
