Entering Adjust Mode - Burnham Water boiler Installation, Operating And Service Instructions

Xii. Operation (continued)
D.
User Interface (continued)

4. Entering Adjust Mode

The "Adjust mode" screen is accessed from the
"Home" screen. The "Adjust Mode" provides
contractors access to view and adjust additional
information.
a. Entering Adjustment Mode
The Sage2.1 is factory programmed to include
basic modulating boiler functionality. These
settings are password protected to discourage
unauthorized or accidental changes to settings.
User login is required to view or adjust these
settings:
i. Press the "Adjust" button on the Home
screen.
ii. Press the "Adjust" button on the Adjust
Mode screen or Press Contractor for service
provider contact information.
iii. Press "Login" button to access password
screen.
iv. Press 3-digit display to open a keypad.
Enter the password (Installer Password is
76) and press the return arrow to close the
keypad. Press the "Save" button.
v. Press the "Adjust" button to enter
Adjustment mode.
b. Editing Parameters is accomplished as follows:
Value to be edited: Use the
buttons to edit a value. While editing a value
it will blink until it has been accepted or
cancelled as described below. A value is
also cancelled by leaving the screen without
accepting the value.
Accept Edit: Press the
newly edited value.
Cancel Edit: Press the
newly edited value and go back to the original
value.
Password required to
Installer Password =
Press 3-digit display to
i
1
6
Note: the value modified
with the increase and
decrease buttons is not
button to confirm
accepted unless this
button is also pressed
button to cancel
For Service Contact:
CONTRACTOR NAME
ADDRESS
PHONE NUMBER
Get past here
76
Input Password
076
ES CL
2 3 4 5
C R
B
7 8 9 0
S
After entering the
password press
To return to password
screen
i
Central Heat
CH Setpoint
<
180
Accept Edit
Increase &
Decrease
buttons
Adjust Mode
Warning! Only Qualified
Technicians Should Adjust
Controls, Contact Your
Qualified Heating Professional
Contractor
Adjust
Login to Access
i
Adjustment Mode
Access Level: Installer
Login
Press 3-digit display to
i
Input Password
000
Press Save to enter password
Save
Adjust
After password is Saved
These buttons access
Adjust mode screens
Value to be edited
(blinks while editing)
>
F
Cancel Edit
Value
Adjust
101