Table of Contents
Advertisement
DESCRIPTION:
The HPT 100F is a flow-through style transmitter
while the HPT 100S is a single-ended or deadleg
style. Each style is available with a variety of tube
stub and face seal connections. Electrical connection
is via either a Bendix® compatible 4 pin connector or
a flying lead pigtail. The small size and light weight
of the HPT 100 eliminates the need for bulky
mounting hardware and mechanical supports.
FUNCTIONAL SPECIFICATIONS:
SERVICE:
AVAILABLE RANGES:
OUTPUT:
POWER SUPPLY:
LOOP RESISTANCE (4 - 20 mA.): 900 ohms at 30 Vdc; 0 ohms at 12 Vdc
OUTPUT LOAD (0 - 5 Vdc):
SPAN/ZERO ADJUSTMENT:
TEMPERATURE LIMITS:
COMPENSATED:
OPERATING:
STORAGE:
HUMIDITY:
OVERRANGE:
BURST PRESSURE:
HAZARDOUS LOCATIONS:
INTRINSICALLY SAFE:
DIVISION 2:
Note: NEMA 4X/IP56 applies to pigtail terminations version only
*(vent through cable to dry environment)
DIELECTRIC ISOLATION:
Liquid, gas or vapor
vac to 100 psig, vac to 250 psig, vac to 1000 psig,
vac to 2000 psig, vac to 3000 psig. Alternate ranges, including
Bar and lower ranges, are available.
4-20 mA, 2 wire, current limited with
reverse polarity protection or
0-5 Vdc (Calibrated 0.1- 5.1 Vdc)
12 to 30 Vdc
> 50K ohms
+/- 5% of span minimum
O
O
0
C to 50
C
O
O
-25
C to 85
C
O
O
-40
C to 85
C
0-95% RH (pigtail cable) *
®
0-95% RH (Bendix
type >=500 psig)
®
0-80% RH (Bendix
type <500 psig)
150% of Full Scale
400% of Full Scale
Class I, Division 1, Groups A, B, C & D, NEMA 4X (IP56)
Approved Barrier Required
Class I, Division 2, Groups A, B, C & D, NEMA 4X
Protective Enclosure or Conduit Connection Required
100V DC
pg. 1-2
Advertisement
Table of Contents
