Regulatory Compliance - Socket Bluetooth GPS Receiver Quick Start Manual

Regulatory Compliance

The Socket Bluetooth GPS Receiver is designed to be compliant with the rules and
regulations in locations where they are sold and will be labeled as required. This
product is type approved — users are not required to obtain license or authorization
before using.
This product has been certified as conforming to technological standards. Therefore,
the following actions are punishable by law:
• Disassembly or modification of this product
• Removal of identification labels on the back of the product
The frequency used by this product is also used by industrial, scientific and medical
devices, such as microwave ovens, as well as wireless detectors for motion detectors,
such as those requiring licenses used on manufacturing lines or similar radio
transmitters (all of these wireless devices will be called "other wireless transmitters"
below).
1. Before using this system, confirm that other wireless transmitters are not in use
nearby.
2. In the unlikely event that there is electronic interference between this system and
other wireless transmitters, quickly change the location of operation or stop
operating the unit (cease signal transmission).
3. If other electrical interference or related problems occur, contact Socket technical
support at +1-510-744-2720.
Radio Frequency Interference Requirements
This device complies with part 15 of the FCC rules and Industry Canada RSS 210.
Operation is subject to the following conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Change or modification not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This equipment is ETS 300 328-2, ETS 301 489-1 and ETS EN301 489-17 compliant.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference, in which case the user will be required to
correct the interference at his or her own expense.
In order for this device to comply with FCC rules, under the provision of Part
15.247(b)(c), it must operate in a manner that ensures that the public is not exposed to
radio frequency levels in excess of the Maximum Permissible Exposure (MPE) limits.
To comply with Industry Canada RF exposure compliance requirements, the following
antenna installation and device operating configurations must be satisfied: "The
installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general