Time Alignment - Panasonic CQ-VD6503W2 Instruction Manual

TEST TONE
(Test tone output)
OFF
: disables the test tone
ON
: enables the test tone
¡ When the test tone is set to on, test signal (a continu-
ous tone) is output from each speaker for approximately
2 seconds.
Adjust the output balance so that the tone appears to
have the same volume from each speaker.
Adjusting the output balance:
Adjust the volume of all of the other speakers to the vol-
ume level of the speaker from which the test signal
appears to be the quietest.

TIME ALIGNMENT

(Delay time setting of each speaker)
Adjusting the timing with which the audio from each
speaker reaches the listener's position
(Center speaker delay time set-
CENTER
ting)
] [
: down, : up
Setting range: 0 ms to 5 ms (1 ms steps)
(Surround speaker delay time
SUR
setting)
] [
: down, : up
Setting range: 0 ms to 15 ms (1 ms steps)
¡Make this adjustment while listening to sound.
¡If the speaker setting is
speaker cannot be selected.
¡When "PRO LOGIC" is displayed, 15 ms are automatically
added to the delay time setting for the surround speakers.
Note:
¡While the private
mode is active, only
and
FRONT L
can be
FRONT R
adjusted.
default:
OFF
1 ms = 0.001 seconds
default: 0 ms
1 ms = 0.001 seconds
default: 0 ms
for a speaker, that
NONE
SOURCE LEVEL
Setting the AV1/AV2 input level
Make this setting if it is not possible to adjust the volume
through the connected device (on the output side).
AV1 LEVEL (Setting for AV1)
LOW : sets the level low/sound volume increases
HIGH : sets the level high/sound volume decreases
AV2 LEVEL
(Setting for AV2)
LOW : sets the level low/sound volume increases
HIGH : sets the level high/sound volume decreases
Note:
¡If the input level from AV1/AV2 is too high, the audio
will not be output normally.
¡After setting the input level
The volume can be adjusted by pressing [+] or [–]
(VOL) on the remote control or turning rotary volume
controller on the unit.
CROSS OVER
Cut off frequency
LPF CUT OFF (Sub-woofer Low Pass Filter)
] [
: down, : up
HPF CUT OFF
(High Pass Filter)
] [
: down, : up
Setting range: off, 63 Hz to 200 Hz
Note:
¡This setting is not available if
¡
is enabled only on the front speakers
HPF CUT OFF
(R/L) and rear speakers (L/R).
default:
HIGH
default:
HIGH
Setting range: 63 Hz to 200 Hz
default: 125 Hz
default: off
is set to
CS Auto ON
CQ-VD6503W
34
.
35