Operating Temperature; Manual Operation; Airflow Direction Control - Carrier WALL MOUNTED AIR CONDITIONER Owner's Manual

Wall mounted air conditioner
Table of Contents

Advertisement

OPERATING INSTRUCTIONS
NOTE: This manual does not in cl ude Remote Controll er Operatio ns, see the
<<Remote Controller Instruction>> packed with th e unit for details .

Operating temperature

Mode
Cooling operation
Temperature
Room temperature
O
O
17 C~32 C
O
O
(62 F~90 F)
0
50
Outdoor temperature
32
122
-15
50
5
For the models with low
temperature cooling system
NOTE:
1. Optimum performance will be achieved within these operating temperatures.If air
conditioner is used outside of the above conditions, certain s afety protect ion features
might come into operation and cause the unit to function abnormally.
2. If the air conditioner runs for a long time in cooling mode and the humidity is high(over
80%) , condensed water may drip out of the unit. Please sets the vertical air flow louver to
its maximum angle (vertically to the floor), and set HIGH fan mode.
Suggestio n: For the unit adopts an Electric Heater, when the outside ambient temperat ure
is below 0 C(32 F), we strongly recommend you t o keep the machine plugged in order to
O
O
guarantee it running sm oothly.

Manual operation

Units are equipped with a switch to run emergency operation mode. It can be accessed by
opening the front panel. This switch is used for manual operation in case the remote controller
fails to work or maintenance necessary.
AU TO/COOL
Manual switch
Manual c ontrol button
( )
1
Suspensi on bars
AU TO/COOL
Manua l control button
Manual switch
( )
2
Heating operation Drying operation
O
O
O
10 C~32 C
0 C~30 C
O
O
O
(50 F~90 F )
(32 F~86 F)
-15
30
0
5
86
32
122
NOTE: The unit must be turned off before
ope rating the ma nual control button. If the
unit is operational, continue pressing the
manual control b utton until th e unit is off.
Open and lift the front panel up to an angle
1
until it remains fixed with a clicking sound.
For some models, please use suspension
bars to prop up the panel.
2
One press of the manual control switch will
lead to the forced AUTO operation. If press
the switch twice within five seconds, the unit
will operate under forced COOL operation.
3
Close the panel firmly to its original
position.
CAUTION:
This switch is used for testing purposes
only. You had better not choose it.
To restore the remote controller operation,
use the remote controller directly.

Airflow direction control

O
O
50
Range
122
D eflector rod
Ra nge
OPERATING INSTRUCTIONS
Adjust the air flow direction properly otherwise it
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal/vertical louver using the remote
controller. For some models, the vertical louver can
only be adjusted manually.
To set the horizontal/vertical air flow direction
Perform this function while the unit is in operation.
Use the remote controller to adjust the air flow direction.
The vertical/horizontal louver changes 6 degree in angle
for each press, or swing up and down automatically.
Please refer to the REMOTE CONTROLLER OPERATION
,,
MANUAL
for details.
For some models, the vertical louver can only be adjusted
manually. Move the deflector rod manually to adjust the air
flow in the direction you prefer.
IMPORTANT
:Do not put your fingers into the panel of
blower and suction side.
The high-speed fan inside may
cause danger.
CAUTION
Do not operate the air conditioner for long periods with
the air flow direction set downward in cooling or
dehumidifying mode. Otherwise, condensation may
occur on the surface of the horizontal louver causing
moisture to drop on to the floor or on furnishings.
When the air conditioner is started immediately after it
was stopped, the horizontal louver might not move for
approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug power for a few seconds,then restart
the air conditioner.
Do not operate unit with horizontal louver in closed
position.

Advertisement

Table of Contents
loading

Table of Contents