Vxr-1000 Installation; Vxr-1000 Connections - Vertex VXR-1000 Service Manual

The VXR-1000 must only be installed in vehi-
cles having a negative ground electrical system.
Mount the transceiver where the Indicators, con-
trols, and microphone are easily accessible, us-
ing the supplied mounting bracket. The VXR-
1000 may be installed in any position, but should
not be positioned near a heating vent nor any-
where where it might interfere with driving (ei-
ther visually or mechanically).

VXR-1000 Installation

Choose a mounting location with sufficient
clearance for the VXR-1000, plus space for
ventilation around the cooling fan and above
and below the VXR-1000. Using the mount-
ing bracket as a template for the mounting
holes, use a 4.8 mm (3/16") bit to drill the
mounting holes, and secure the mounting
bracket with the supplied screws, washers,
and nuts (see diagram).
Position the VXR-1000 in the bracket so that
the holes in the side are aligned with those in
the bracket, and bolt the VXR-1000 into place
using the supplied short screws and flat
washers.

VXR-1000 Connections

The VXR-1000 provides a convenient rear-pan-
el Accessory Connector for easy connections to
your transceiver. The connections to this jack are
in accordance with a standard adopted by many
commercial radio. However, we recommend
that you verify the connections to any cable you
already own by comparison to the pictorial be-
low.
Installations
5