Vxr-1000 Trunking Interface Manual; Equipment Required; Vxr-1000 Interconnections To Ftl-7011; Interconnections To Vx-2000/Configuration - Vertex VXR-1000 Service Manual

This document outlines the interconnections and
hardware settings required for interface of the
Vertex VXR-1000 Compact Mobile Repeater to
the Vertex VX- series of mobile transceivers in a
trunked environment (using the Vertex VX-
Trunk System).
The illustration below outlines the basic config-
uration of a VX-Trunk system, using the VXR-
1000 as a range extender for a portable trans-
ceiver.
1. E R
QUIPMENT EQUIRED
Portable Transceiver: Must have a DTMF En-
Mobile Transceiver: Must be configured for
2. I
NTERCONNECTIONS FROM
2-1: Interconnections to FTL-7011/Configuration
2-1-1: VXR-1000 Internal Jumpers
JP1004 Open
JP1005 Jumpered

VXR-1000 Trunking Interface Manual

coder installed.
operation within VX-
Trunk System. Compat-
ible models include FTL-
7011, VX-2000, and VX-
3000. Please refer to the
VX-Trunk System docu-
mentation for configura-
tion details for the mo-
bile transceiver.
VXR-1000
M T
OBILE RANSCEIVERS

2-1-2: VXR-1000 Interconnections to FTL-7011

Pin 1: GND
Pin 2: Mobile Transmit Audio
Pin 3: Power Supply Control
Pin 4: Mobile PTT Output
Pin 5: Vcc (13.8 V)
Pin 6: Mobile Receive Audio
Pin 7: Mobile COR Detect
Pin 8: Mobile Microphone Audio
Pin 9: Mobile TX detect/Mobile Mic. PTT

2-2: Interconnections to VX-2000/Configuration

2-2-1: VXR-1000 Internal Jumpers
JP1004
JP1005
2-2-2: VX-2000 Internal Jumpers
JP1002
JP1003
JP1004
JP1005
JP1007
JP1008
JP1009
Connect a jumper from Pin 3 of J1003 to
the shared side ofJP1009/Pin 4 of J1007.
Remove R1010
Connect a jumper from Pin 7 of J1003 to
the shared side of JP1008/Pin 1 of J1007.
Connect a jumper between Pin 4 of J1003
and Pin 6 of the connector of the VTM-20
Trunking Controller board.
2-2-3: VXR-1000 Interconnections to VX-2000
The chart below describes the individual
wire functions for the cable connected be-
tween the D-Sub 9-pin connectors on the
VXR-1000 (J1004) and VX-2000 (J1003).
TO
Pin 1: GND
Pin 2: Mobile Transmit Audio
Pin 3: Power Supply Control
Pin 4: Mobile PTT Output
Pin 5: Vcc (13.8 V)
Pin 6: Mobile Receive Audio
Pin 7: Mobile COR Detect
Pin 8: Mobile Microphone Audio
Pin 9: Mobile TX detect/Mobile Mic. PTT
VXR-1000 DSUB 9-pin
Accessory Connector
Open
Jumpered
Jumpered
Open
Open
Open
Open
Open
Open
VXR-1000 DSUB 9-pin
Accessory Connector
FTL-7011
Pin 8 of J2006
Pin 4 of J2006
Pin 12 of J2006
Pin 1 of J2006
Pin 9 of J2006
Pin 3 of J2001
Pin 1 of J2001
No Connection
No Connection
VX-2000
Pin 5 of J1003
Pin 3 of 1003
Pin 8 of J1003
Pin 7 of J1003
Switched
13.8VDC
output from the
Power Switch
Pin 2 of J1003
Pin 4 of J1003
No Connection
No Connection
11