Panasonic KX-TD816CE User Manual Addendum page 29

2.2
— Using the Jog Dial (With a KX-T7433 / KX-T7436 / KX-T7531 / KX-T7533 / KX-T7536)
See Combination Table 2.
1. Press 6 and then rotate the Jog Dial one pulse to enter "M".
2. Press 4 and then rotate the Jog Dial six pulses to enter "i".
3. Press 5 and then rotate the Jog Dial four pulses to enter "k".
4. Press 3 and then rotate the Jog Dial four pulses to enter "e".
OR
1. Press 2 and then rotate the Jog Dial until "M" appears.
2. Press 2 and then rotate the Jog Dial until "i" appears.
3. Press 2 and then rotate the Jog Dial until "k" appears.
4. Press 2 and then rotate the Jog Dial until "e" appears.
Notes
• Pressing the SHIFT button alternates between capital and lower case letters. Once this
button is pressed, that letter SHIFT mode remains until SHIFT is pressed again.
• To erase the last word (to backspace), press the CONF button.
(The CONF button becomes the "←" (backspace) key when using the overlay.)
• To erase all of the data, press the CLR (S2) button.
• If you keep rotating the Jog Dial, all of the characters will be displayed in order.
<Example> If you rotate the Jog Dial after pressing 2, all of the characters will appear in the
following order:
A a B b ···· Z z (space) ! ? . , ' : ; * / + – = < > # $ % & @ ( ) A a B b
····
Conditions
• The default is "Not Stored".
• Up to ten dialling numbers and names can be assigned. Each dialling number has a
maximum of sixteen digits and each name has a maximum of ten characters.
Programming
29