Download
Share
Print this page
Two-Rock Classic Type 2 Owner's Manual
  1. Manuals
  2. Brands
  3. Two-Rock Manuals
  4. Amplifier
  5. Classic Type 2
  6. Owner's manual

Two-Rock Classic Type 2 Owner's Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
OWNERS MANUAL

Advertisement

loading
Need help?

Need help?

Do you have a question about the Classic Type 2 and is the answer not in the manual?

Questions and answers

Related Manuals for Two-Rock Classic Type 2

Summary of Contents for Two-Rock Classic Type 2

  • Page 1 OWNERS MANUAL...
  • Page 2 Dear Customer, Thank you for your purchase of a amplifier from Premier Builders Guild. As a discerning guitarist, you know the road to great tone begins with great components. Our Classic Design, carefully selected parts and hand-built approach combine to make an extremely versatile instrument. Please take the time to read this manual.

  • Page 3: Front Panel Functions

    Front Panel Functions 1. Input Jack- High impedance input to the amplifier. Plug in your instrument here. 2. FET Gain- The FET (Field Effect Transistor) feature consists of a single stage high impedance preamp/buffer. This feature can be switched in and out via the front panel switch (“ON” is “up” position) or footswitch.
  • Page 4 12. Q1/Q2- This switch allows you to choose between 2 completely different equalization settings. Q1 is a lower gain setting, with extended midrange and bass available when used in conjunction with the middle and bass controls as well as the deep switch. This setting is suitable for any style requiring a pure clean tone with a nice round bottom and plenty of headroom.

  • Page 5: Rear Panel Functions

    Rear Panel Functions 1. A/C Input- Connects the amplifier to A/C power via the power cord supplied. Unless otherwise specified, your amplifier is designed to operate on 120 volts A/C, 60 cycles, ONLY. 2. Fuse- See Fuse Chart 3. Power Switch- Turns power on. 4.

  • Page 6: Fuse Chart

    pickups. “Off” disengages the feedback circuit, and “Min” adds negative feedback suitable for low output single coil pickups. These settings are recommendations only; we suggest you experiment with various combinations of settings of both preamp and output negative feedback. You can change the degree of articulation, compression, and “bloom”...
  • Page 7 Set master volumes and effects return controls to zero. DO NOT apply any signal to the input during the biasing procedure! Take unit off standby and allow a few seconds for the circuit to stabilize. Set voltmeter to Millivolt scale (or lowest volt scale 60 millivolts=.060 volts.) With meter grounded to chassis and + probe at test point, measure voltage.
  • Page 8 Please contact us with any other questions or comments that you may have. We look forward to hearing from you! PHONE: 1(707)584-TONE (8663) (M-F 9am-5pm PST) FAX: 1(707)584-8661 ADDRESS: Two-Rock 619 Martin Avenue, Suite 6 Rohnert Park, CA 94928 SERVICE: service@two-rock.com WEB: www.two-rock.com...
  • Page 10 This is a product of Premier Builders Guild 619 MARTIN AVENUE, SUITE 6 ROHNERT PARK, CA 94928 707-584-8663 www.two-rock.com SERIAL NUMBER: _____________________________...

This manual is also suitable for:

Classic type 1