Connecting The Speaker System; Time Setting - Sangean DMS-16 User Manual

Connecting the speaker system

Extend the speaker wires and connect to the speaker output L
and R. Make sure the Channel (L and R) and also polarity (+ and -)
are all correctly connected. On the supplied speaker wires,
the copper wire is defined as Positive in polarity while tin plated
wire is Negative in polarity.
Note:
Do not switch on the power until the speaker system
is connected.

Time setting

1. Turn on the system by pressing standby button.
2. Press and release MODE button , display will flash 0:00.
3. Press and release Time Set button
will flash.
4. Press Tuning +/- button to select required hour then press
Time Set button again to confirm hour setting. Display minute
digit will flash.
5. Press Tuning +/- button to select required minute then press
Time Set button again to finalize time setting.
Note :
The time can be auto adjusted by FM-RDS Auto clock set
(CT) but can't be auto adjusted by DAB signal.
7
10
20060919_DMS-16_381P501-A_GB.p65
, display hour digit
2006/9/19, ¤W¤È 09:15