Mitsubishi Electric Mr.Slim PLA-RP100AA2 Service Manual page 33

OPERATING PROCEDURE
9. Removing the drain pump and drain sensor
(1) Remove the panel. (See photo 6)
(2) Remove the fan guard. (See photo 1)
(3) Remove the bell mouth. (See photo 2)
(4) Remove the electrical box. (See photo 3)
(5) Cut the drain hose band with scissors and pull out the
drain hose from the drain pump.
(6) loosen the screw(2 screws) and remove the screw B
(1 screw).Slide the drain pump in the direction of the
arrow C and remove it.
(7) Remove the drain sensor with its holder from the drain
pump.
10. Removing the heat exchanger
(1) Remove the panel. (See photo 6)
(2) Remove the fan guard. (See photo 1)
(3) Remove the bell mouth. (See photo 2)
(4) Remove the electrical box. (See photo 3)
(5) Remove the drain pan. (See photo 7)
(6) Remove the turbo fan. (See photo 4)
(7) Remove the 3 screws of the piping cover, and pull out
piping cover.
(8) Remove the 4 screws of the outer wall cover, and pull out
the outer wall cover.
(9) Remove the screw of the coil support.
(10) Remove the 2 screws of the coil.
(11) Pull out the heat exchanger.
PHOTOS & ILLUSTRATIONS
Photo 8
Screw A
Drain hose
Photo 9
Heat exchanger
Coil
support
Photo 10
Screw
Outer wall cover
33
Drain sensor
Fixing band
Drain pump
Coil support
Coil screws
Screws of
Piping cover
piping cover
C
Screw B
Coil
support