Wireless Remote Controller - Mitsubishi Electric Mr.Slim PLA-RP100AA2 Service Manual

Wireless remote controller

display
OPERATION MODE display
Operation mode display indicates which op-
eration mode is in effect.
display
The vertical direction of air flow is indicated.
display
FAN SPEED display indicates which fan
speed has been selected.
ON/OFF button
The unit is turned ON and OFF alternately
each time the button is pressed.
FAN SPEED SELECT button
Used to change the fan speed.
MODE SELECT button
Used to switch the operation mode between
cooling, drying, blowing, heating and auto
mode.
w In case the outdoor unit is cool only type,
the heating mode is not available.
CHECK-TEST RUN button
Only press this button to perform an inspec-
tion check or test operation.
Do not use it for normal operation.
VANE CONTROL button
Used to change the air flow direction.
display
CHECK TEST RUN
CHECK&TEST RUN display indicates that
the unit is being checked or test-run.
display
MODEL SELECT
Blinks when model is selected.
CHECK TEST RUN
MODEL SELECT
AMPM
AMPM
NOT AVAILABLE
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER
TEST RUN
SET RESET CLOCK
8
Lights up while transmission to the indoor
unit is mode using switches.
SET TEMP. display indicates desired temper-
ature set.
CLOCK display
Displays the current time.
Displays when in timer operation or when
˚C
setting timer.
"
Displays the order of timer operation.
"
Displays whether timer is on or off.
SET TEMPERATURE button sets any desired
room temperature.
TIMER CONTROL buttons
AUTO STOP (OFF timer): when this switch
h
is set, the air conditioner will be au-
tomatically stopped at the preset time.
min
AUTO START (ON timer): when this switch
is set, the air conditioner will be automatical-
ly started at the preset time.
h and min buttons
Buttons used to set the "hour and minute" of
the current time and timer settings.
LOUVER button
This switch the horizontal fan motion ON
and OFF.
(Not available for this model.)
display
display
TIMER display
" " " display
" " " display
button
CLOCK button
RESET button
SET button