Introduction; Unpacking; Voltage Setting - Viola Systems FORTE MONO Owner's Manual

INTRODUCTION

Thank you for choosing the VIOLA Forte Amplifier.
design and manufacture of the Forte and if properly used, it will give a lifetime of
musical enjoyment. We strongly recommend that you read these instructions before
you attempt to use the unit, so that you can be sure it is set up to give optimum
performance.

UNPACKING

Please keep all of the packing materials in case you ever need to ship the unit.
Should you need to return the unit to the factory, you must use the original shipping
carton. The use of any ot her packing may result in the product sustaining damage in
transit. Such damage is not covered by the warranty. Replacement shipping cartons
may be obtained via your VIOLA dealer, national distributor or directly from the
factory.
After unpacking the unit, please confirm that the following items are present:
2 VIOLA Forte power amplifiers (When purchased as a pair)
1 user manual
1 three-conductor mains cord for each amplifier
2 spare mains fuses.
T5A for units set to 100V or 120V operation
T3A for units set to 220V or 240V operation
If any of the above item s are missing, or if the amplifiers show any signs of damage,
please contact your VIOLA dealer immediately.

VOLTAGE SETTING

Before going any further please, confirm that the unit is set to operate on the mains
voltage you plan to use. The setting
mains input receptacle located on the unit's rear panel.
the MAINS FUSE for more details. If the setting on your unit is not correct, contact
your VIOLA dealer. Only a VIOLA approved technician should change the voltage
setting. Do not attempt to do this yourself. Should you set the unit to the wrong
voltage, you risk personal injury and you may also cause serious damage to the unit
which will void the warranty.
Viola Forte Manual Rev 2
Great care has gone into the
is indicated on the fuse cover. This is on the
Page 4 of 15
Please see the section on
th
7 September 2005