Add Port Range Forwarding Rule - AXIMCom MR-102N User Manual

8.1.2 Add Port Range Forwarding Rule

1. Click on [Add] tab. You will see the following screen.
2. Configure [Add Port Range Forwarding Rule] Settings following the instructions below
Sequence Number
Rule Name
Rule Enable
External Interface
Protocol
External Port Range
Internal IP
Internal Port Range
This defines the sequences (priorities) of the port forwarding rules. If a
packet fits the conditions setup by the port forwarding rules, the packet
will then be forwarded according to the 1st rule from the top of the list.
Enter the name of the port forwarding rule.
Enable/Disable this port forwarding rule.
Choose WAN1 or WAN2 as the External port forwarding interface.
Choose TCP, UDP or TCP/UDP for the rule to be applied.
Set up the External Port Range for the rule to be applied.
Set up the Internal IP for the rule to be applied.
Set up the Internal Port Range for the rule to be applied.
61