Table of Contents
Advertisement
Rodgers 538/i548
Other functions
4.
Other functions
This chapter presents the capabilities of the 538/i548 in greater detail. Use it to become more familiar with the many
innovative features of your fine Rodgers instrument.
Console display and controls
The 538/i548 is equipped with a graphic display with an
intuitive "Quick Menu" structure for many of the
console functions described in this section. The display
normally indicates the transposition ("Transpose"), and
memory bank/memory ("M") settings. But there are
other functions you can set, including MIDI settings,
Tremulant rate and depth, and many others.
Three controls are used to select the features found in
the display: [QUICK¥MENU] is used to activate menu
mode and confirm the selection of items. By selecting a
menu item, you go to a lower level. [ø¥EXIT] is used to
return to the previous level (when pressed briefly), or to
the main page (when held down).
Return to the previous level or main page.
Open the menu and confirm selection.
The Select knob is used to select items. As stated above,
your selection needs to be confirmed by pressing the
[QUICK¥MENU] piston. The data entry wheel is used to
change the settings of the selected parameter.
Select an item
shown in the dis-
play.
The following section describes how the console
display is used, outline the basic navigation
techniques and gives you a map of what can be
found and set by the organist. After that, each
control found in the display will be described in more
detail.
28
Accessing organ control functions
Most console functions can be accessed in the
following way:
(1) Press [QUICK¥MENU].
(2) Use the Select knob to select a menu heading.
The following menu sections are available:
Pipe Modeling*
Room Modeling*
Console
Audio Control*
Song Recorder
Sections marked with a (*) contain parameters you
may never need. They have been provided to allow
you (or your Rodgers dealer) to fine-tune the 538/
i548's behavior and sound.
(3) Confirm your choice by pressing [QUICK¥MENU].
This takes you to a lower level with several options.
(4) Choose an item with the Select knob.
(5) Confirm your choice by pressing [QUICK¥MENU].
(6) Change the setting with the data entry wheel.
The next step depends on what you want to do next:
(7) Do one of the following:
To use your setting and start
Set the value
playing:
of the selected
item.
To set another item or save
your settings:
(8) Save your settings if you wish to keep them.
Normally, these settings are temporary and lost when
the organ is powered off. If desired, a save procedure
of the "Quick Menu" parameters can be performed,
which causes the new settings to be retained when
the organ is turned off. See "Saving general settings"
on p. 42.
(9) When finished, press and hold the [ø¥EXIT] piston to
return to the main page.
Orch/MIDI Coup*
MIDI Setting*
Orchest Setting*
Memory Setup
Demo Songs
Press and hold [ø¥EXIT]
until the master page
appears.
Briefly press [ø¥EXIT] and
repeat steps (2)~(6).
Advertisement
Table of Contents
