Andrew Type 183 Assembly Instructions Manual page 9

GROUNDING INSTRUCTION FOR GROUND POLE
NOTE: All installations to conform to the latest issue of the National Electric Code and local codes.
NOTE: All installations to
conform to latest issue of
National Electrical Code.
Ground antenna mount
assembly and feed cables
in accordance with current
National Electrical code
and local codes.
These illustrations depict
typical grounding methods
for the ground pole and
feed cables. Clamps that
provide a solid connection
between ground wire and
ground source should be
used. Tighten and torque
all hardware.
Ground
Pole
Drill Hole Through
One Wall of Tube
with 5.5 mm (7/32 in)
Twist Drill and Apply
Sealant After Assembly
to Prevent Corrosion.
Cable Grounding Components
Are Not Supplied
Ground
Lug
Ground Block
NEC Section 810-20
(Not Supplied)
Ground Wire
NEC Section 810-20
(Not Supplied)
8
6.3 mm (1/4 in)
External Tooth
Lock Washer
6.3 mm (1/4 in) - 20 UNC
x 15.8 mm (5/8 in)
Type D Point Hex Head
Tapping Screw
Ground Wire Typical
(#10 AWG Copper, #8
Aluminum) Refer to NEC
Section 810 and Local
Electric Codes For The
Specific Area Requirements.
Coaxial Cable
To Receiver
(Not Supplied)
Coaxial Cable
From LNB
(Not Supplied)