Electromagnetic Compatibility (Emc) - Axis M1025 Installation Manual

Electromagnetic Compatibility (EMC),

on page 3.
• Low Voltage (LVD) Directive 2006/
95/EC. See Safety, on page 4.
• Restrictions of Hazardous
Substances (RoHS) Directive 2011/65/
EU. See Disposal and Recycling, on
page 4.
A copy of the original declaration of
conformity may be obtained from
Axis Communications AB. See Contact
Information, on page 5.
Electromagnetic Compatibility
(EMC)
This equipment has been designed and
tested to fulfill applicable standards
for:
• Radio frequency emission when
installed according to the
instructions and used in its intended
environment.
• Immunity to electrical and
electromagnetic phenomena when
installed according to the
instructions and used in its intended
environment.
USA -
This equipment has been
tested using a shielded network cable
(STP) and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Canada -
This Class B digital
apparatus complies with Canadian
ICES-003.
Europe -
This digital equipment
fulfills the requirements for RF
emission according to the Class B limit
of EN 55022.
This product fulfills the requirements
for immunity according to EN 61000-
6-1 residential, commercial and light-
industrial environments.
This product fulfills the requirements
for immunity according to EN 61000-
6-2 industrial environments.
This product fulfills the requirements
for immunity according to EN 55024
residential and commercial
environments.
Australia/new Zealand
This digital equipment fulfills the
requirements for RF emission
according to the Class B limit of AS/
NZS CISPR 22.