Miele CVA 6800 Operating And Installation Instructions page 73

Problem
There is no milk or
milk froth being
dispensed from
the central spout.
"Fill and insert milk
flask" appears in
the display
although the milk
flask has been
filled and inserted
in the coffee
machine.
"Empty the drip
tray" appears in
the display
although the drip
tray has been
emptied.
The machine front
will not close
properly.
Drink preparation
is cancelled.
Possible cause and remedy
The milk pipework or the air intake tube is blocked.
^ Follow the instructions in "Cleaning blockages from the
milk pipework".
The lid of the milk flask could be dirty preventing the sensors
from working properly.
^ Clean the milk flask and the lid thoroughly (see "Cleaning
blockages from the milk pipework").
The drip tray has not been correctly positioned inside the
machine.
^ Push the drip tray back in as far as it will go.
The sensors on the drip tray are not working properly.
^ Switch the coffee machine off with the On/Off sensor K.
The metal contact discs are dirty.
^ Clean and dry the metal contacts thoroughly (see
"Cleaning and care - Drip tray").
The containers are not pushed into the machine completely.
^ Check the containers.
The hinges are not aligned correctly.
^ Adjust the hinges (see "Installation - Adjusting the hinges").
If the water container becomes empty while a drink is being
made, after the water container is filled and replaced
"Continue? Yes / No" will appear in the display. If you do not
confirm "Yes" within 5 minutes, the drink will be cancelled.
Problem solving guide
73