Satechi Cyclone Micro 2 User Manual page 34

Please ensure that the device is also connected to your TV via the supplied
composite cable during the firmware update. When the screen goes blank,
select the composite connection as the active input on your TV.
The The player player no no longer longer
The The player player no no longer longer responds:
If the Cyclone Micro 2 no longer responds to the remote control, the batteries
may be dead. Please replace them with new ones.
Obstruction of the infrared's field of vision may also cause unresponsiveness
in the player. Please remove all potential obstructions between the player
and remote control
Please clean the infrared receiver.
No No No No audio audio audio audio output: output: output: output:
Please check that the volume for your TV, home entertainment system and
Cyclone Micro 2 has not been set too low. Also check that the sound has not
been switch off via the mute button.
The audio digital output may also be incorrectly configured.
The The player player has has failed failed
The The player player has has failed failed during
To recover the Cyclone Micro 2 from a firmware upgrade failure, power off the
player and disconnect the power cable.
Insert a USB pen drive containing the firmware. Please note that only the
firmware update files should be on the pen drive.
Connect the power cable back into the Cyclone Micro 2 and switch it on. This
should cause the player to attempt to reinstall the software.
responds: responds:
responds:
during during Firmware Firmware upgrade: upgrade:
during Firmware Firmware upgrade: upgrade:
Cyclone Micro 2 Multimedia Player
Page 34.
Version 0.7