Viewing The Connections - Sharp LC-32LE360EN Operation Manual

Viewing the Connections

Connector Type
Scart
Connection
(back)
VGA
Connection
(back)
PC/YPbPr
Audio
Connection
(side)
HDMI (1,2,3)
Connection
(back)
SPDIF
(Coaxial Out)
Connection
(back)
Side AV
(Audio/Video)
Connection
(side)
Headphone
Connection
(side)
YPbPr Video
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
LAN
Ethernet (LAN)
Connection
(back)
Cables
Side Audio/Video
Connection Cable PC Audio Cable
(Supplied) (Not supplied)
Side AV
Connection Cable
(supplied)
PC to YPbPr
Connection Cable
(Not supplied)
English - 9 -
Note: When connecting a device
Device
via the YPbPr or Side AV input,
you mus t use connec ti on
cables to enable connection.
For Side AV input you should
use the supplied cable. See the
illustrations on the left side. | You
can use YPbPr to VGA cable (not
supplied) to enable YPbPr signal
via VGA input. | You cannot use
VGA and YPbPr at the same
time.| To enable PC/YPbPr
audio, you will need to use the
SIDE AV socket with a PC audio
cable (not supplied) for audio
connection, using the supplied
Side AV connection cable's
RED and WHITE inputs.| If an
external device is connected
via the SCART socket, the TV
will automatically switch to AV
mode.| When receiving DTV
channels (Mpeg4 H.264) or
while in Media Browser mode,
output will not be available via
the scart socket. | When using
the wall mounting kit (available
from third party in the market),
we recommend that you plug
all your cables into the back
of the TV before mounting on
the wall. | Insert or remove
the CI module only when the
TV is SWITCHED OFF. You
should refer to the module
instruction manual for details of
the settings. | Each USB input
of your TV supports devices up
to 500mA. Connecting devices
that have current value above
500mA may damage your TV.
| By connecting an HDMI cable
to your TV, you have to use
only a shielded HDMI cable to
guarantee a sufficient immunity
against parasitic frequency
radiation.
If you want to
connect a device to
the TV, make sure
that both the TV and the
device are turned off before
making any connection. After
the connection is done, you
can turn on the units and use
them.