Magnetek Battery Charger Instruction Sheet

Operating Instructions

1. Insert the battery pack (part number BAT-01) into the transmitter.
2. When the charging unit (part number CHR-01) is initially powered on, both LED-A and LED-B will
blink green two or three times (indicating that the charger is in good working order) and then stop
(indicating standby mode).
3. Plug the charging cable (output A or B) into the battery pack charging input slot.
P.O. Box 13615 N49 W13650 Campbell Drive
Milwaukee, WI 53213 Menomonee Falls, WI 53051
Toll-Free Phone 800.288.8178 Phone 262.783.3500
Toll-Free Fax 800.298.3503 Fax 262.783.3510
1. 12-24 VDC Input
2. Charging Output "A"
3. Status LED for output "A"
Figure 1: Charging Unit CHR-01
Figure 2: Inserting the Battery Pack
Figure 3: Plugging in the Charging Cable

Battery Charger

4. Status LED for output "B"
5. Charging Output "B"
Instruction Sheet
For Flex Transmitters
www.magnetek.com
Instruction Sheet No. 0-CHR-03E R0