Magnetek E10695-0 Quick Start Manual

E10695-0, Lead Acid Cell Battery Charger for:
BT644-6, 6 Volt Lead Acid Battery and
BT628-0, 12 Volt Lead Acid Battery.
Note: All new rechargeable battery packs must be charged before usage.
•
Use of this device is intended for charging the BT644-6, 6 Volt battery and the BT628-0, 12 Volt
•
battery, lead acid cell rechargeable batteries only.
Make sure to set the charger voltage switch to the proper output voltage
•
battery.
Do not set the battery on top the charger while charging. The heat of the charger could damage the
•
battery.
•
Do not use this charger for automotive type batteries.
•
Do not attempt to use this product on non-rechargeable battery packs.
•
Please familiarize yourself with the instructions before attempting to use.
•
Do not dispose of a battery pack in fire; it may explode.
•
Do not charge or operate in a hazardous environment.
•
Do not short circuit battery or charger.
•
Do not attempt to charge a damaged battery.
•
Do not attempt to open the battery pack.
•
Recharging a battery only after it is fully discharged will prolong its life.
•
Avoid recharging battery when fully or near fully charged.
•
The charger unit is not intended for outdoor use. Use only indoors.
Keep the battery pack environment cool during charging operation and storage, (i.e., not in direct
•
sunlight or close to a heating source).
•
Always dispose of used batteries per appropriate regulations.
Rechargeable batteries, for longest life, should be recharged at least every 6 months even if they
•
are in storage.
•
Do not open charger, there are no user serviceable items inside.
Do not attempt to operate the charger if it or its cords are damaged.
TC10695-0
N49 W13650 Campbell Drive
Menomonee Falls, WI 53051
Phone: 800-288-8178
Fax: 800-298-3503
Website: www.telemotive.com

GENERAL PRECAUTIONS

before
connecting the
9/22/2003