Maintenance; Troubleshooting - DeWalt DCT410 Instruction Manual

MAINTENANCE

Cleaning
WARNING: Blow dirt and dust off with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.

Troubleshooting

• Make sure the 12V Max* battery is charged.
• Make sure the screen is fully charged.
• Make sure the screen is always attached to the handle set. The
picture may freeze if you attempt to remove the (screen) from the
handle set while taking a photo or video.
• Make sure the battery is installed on the handle set when in use.
• Make sure the camera cable is attached to the handle set properly.
• Make sure the handle set is turned on as well as the screen.
• Make sure the back of the handle set is not covered with debris so
the screen slides on easily and no damage to the screen occurs.
• If the screen freezes or won't turn on, insert a small object (i.e.,
paper clip end) into the reset button located on the back of the
screen.