Maintenance; Troubleshooting; Operating Tips - DeWalt DCT410-XE Instruction Manual

2. Press the forward or back arrow to select the Default Setup option.
3. Press the OK button to navigate to the next screen.
4. Press the forward or back arrow to select NO or YES.
5. Press the OK button to save changes and exit.

Operating Tips

• Use only D WALT 10.8V lithium ion battery.
E
• Ensure the D WALT battery is in good working condition. If the low battery
E
indicator light on the screen is flashing, the battery needs to be recharged.
• To extend battery life, make sure to turn both the screen and the handle set off
when not in use.
• Make sure the screen is fully charged before operation.

MAINTENANCE

Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS51337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.

Troubleshooting

• Make sure the 10.8V battery is charged.
• Make sure the screen is fully charged.
• Make sure the screen is always attached to the handle set. The picture may
freeze if you attempt to remove the (screen) from the handle set while taking a
photo or video.
• Make sure the battery is installed on the handle set when in use.
• Make sure the camera cable is attached to the handle set properly.
• Make sure the handle set is turned on as well as the screen.
• Make sure the back of the handle set is not covered with debris so the screen
slides on easily and no damage to the screen occurs.
• If the screen freezes or won't turn on, insert a small object (i.e., paper clip end)
into the reset button located on the back of the screen.
• If the picture is dim, roll the brightness control switch to brighten the LED light.
15