Fan Motor As’ In Pc - Panasonic NR-B53V1 Service Manual

11.7.2. Fan Motor AS' in PC
1. Remove the Duct PC AS'.
a. Remove 2 screws on the Duct PC AS'.
b. Take out the connector which hides behind the
Duct PC AS' and disconnect it.
Figure of after cover lamp, cover LED AG and
PAS-C28VD2 (DEO) are removed.
2. Remove the Cover Coil PC AS. by removing 2 screws
and pull the upper edge of the Cover Coil PC AS. to
remove. Be careful not to break the wire, let the wire
go through the hole on the Cover Coil PC AS. (refer
diagram in step 3 below).
Note: At this stage, the PAS-C29FGS (VC) must have
already been removed.
3. Remove the Fan Motor A'ssy in PC compartment.
a. Grab and pull out the HOLDER FAN PC A'SSY. Be
careful not to break the wire, let the wire go
through the top left hole of the HOLDER FAN PC
A'SSY.
b. Push the Fan Motor A'ssy towards the reverse
side of the HOLDER FAN PC A'SSY to release it
from the 2 hooks.
60