Table of Contents
Advertisement
Safesight SC9003 Back up camera system
www.qualitymobilevideo.com
3. Monitor wiring harness
The monitor wiring harness is a single harness that has a multi-pin connector on one end
and a series of wires and RCA cables on the other. The black box contains a power filter and
fuse that prevents damage in the event of a short circuit. The multi-pin connector has a tab
that prevents the connectors from being inserted incorrectly to one another.
Note: In the event that the monitor will not respond please check to make sure the
fuse is seated properly and fuse is not blown.
3.1 Identifying the bare wires
Bare Wire color
Connection
Positive + 12 volts – connect this to a
switched power supply at the fuse box so
Red
that the monitor will get power only when
the key is on.
Negative – 12 volts – connect this to the
Black
ground of the vehicle.
Positive + 12 volt trigger – when 12 volts is
applied to this wire it will trigger the
Green
monitor to turn on to the camera input, this
will prevent you from turning the monitor
off until 12 volts is removed from this wire.
Page 6
Advertisement
Table of Contents
