Unit Will Not Turn On When The Vehicle Is Placed In Reverse; Monitor And Camera Will Not Turn On After The Vehicle Is Taken Out Of Reverse; Monitor Randomly Turns On And Off - Safesight SC9003 Installation Manual And User's Manual

Safesight SC9003 Back up camera system
7.3 Monitor and camera will not turn on after the vehicle is taken
out of reverse.
The system should turn on and off manually when the vehicle is running if you have
connected the system as we described in this manual.
• Check monitor power connection to ensure that the red wire has positive 12 volts
anytime the vehicle is running or the key is turned to position 2.
• Check monitor power connection to ensure that the red DC power connector has
positive 12 volts on the center pin and negative 12 volts on the outer shield anytime
the vehicle is running or the key is turned to position 2.
• Check the inline fuse, it should not be blown.

7.4 Monitor randomly turns on and off.

The monitor will randomly turn on or off if the incorrect reverse circuit is used. Many
newer vehicles have light bulbs that have dual filaments. Dual filament bulbs typically have
a three wire connection.
1. Use a voltmeter to determine which wire is the correct one to tap.
2. Meter must read 12 volts when the vehicle is placed into reverse. Any fluctuation
in voltage larger than one volt generally means that this incorrect wire has been
tapped.
3. Tap the reverse wire using a insulated wire tap.
4. Ensure that the trigger wire that runs the length of the vehicle to the monitor has
not been damaged or shorted.
www.qualitymobilevideo.com
Page 23