Bosch CAG180 Operating/Safety Instructions Manual page 11

BM 2610034439 04-14_CAG180 4/1/14 7:26 AM Page 11
DISC GRINDING WHEEL ASSEMBLy
Disconnect battery pack from tool. Be sure
that wheel guard is in place for grinding. Place
BACKING FLANGE and GRINDING WHEEL
on the spindle. Thread on the lock nut and
tighten nut using the supplied lock nut wrench,
while holding the spindle lock in (Fig. 3).
TO REMOVE: Reverse procedure.
Not recommended for use with spin-on
wheels.
TYPE 27
GRINDING
WHEEL
ABRASIVE TyPE 1A & 27A
WHEEL ASSEMBLy
Using the optional type 1A wheel guard, it is
possible to perform limited cutting on small
stock such as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
Always use type 1A protection
W RNING
guard for cutting.
Disconnect battery pack from tool. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
WHEEL on the spindle. Thread on the lock
nut and tighten ut using a lock nut wrench
provided with adapter kit, while holding the
spindle lock in (Fig. 4).
TO REMOVE: Reverse procedure.
TyPE 1 ABRASIVE
STRAIGHT GRINDING WHEELS
Do not use type 1 abrasive
W RNING
wheels
straight/die grinding. This tool is not
designed for use with type 1 abrasive
straight/die grinding wheels.
FIG. 3
SPINDLE
SPINDLE
B CKING
FL NGE
LOCK NUT
FIG. 4
designed for
TYPE 1 (ISO41)
CUTTING WHEEL
-11-
TYPE 27
WHEEL GU RD
B CKING
FL NGE
TYPE 27
GRINDING
WHEEL
LOCK NUT
SPINDLE
TYPE 1
WHEEL GU RD
B CKING
FL NGE
LOCK NUT
TYPE 27
CUTOFF
WHEEL