Bosch CSW41 Operating/Safety Instructions Manual page 11

BM 1619X08893 09-13_BM 1619X08893 09-13.qxp 8/29/13 9:04 AM Page 11
MAXIMUM DEPTH OF CUT STABILITY
ADjUSTMENT
Note; Feature is set during assembly.
Adjustment may be required due to wear and
tear on the tool.
Disconnect plug from power source. Set tool to
zero bevel. Place tool on foot plate onto a level
surface with rear of foot over hanging work
bench by about 2 inches. Loosen the depth
adjustment lever. Set tool to maximum depth
of cut. If the adjustment set screw is in contact
to the motor housing prior to achieving
maximum depth of cut then lower set screw
using a 3/16" Allen wrench until maximum
depth of cut is reached. If set screw is not in
contact with motor housing when maximum
WRENCH USAGE
Wrench provided has several functions other
than loosening/tightening the blade bolt (Fig. 8).
1. Loosening/tightening blade bolt (1/2" wrench)
2. Loosening/tightening combo oil plug/lock
button assembly (1/2" wrench)
3. Loosening/tightening brush caps (slotted
driver)
4. Loosening/tightening bevel/depth levers
when levers are over tightened or additional
tightening is needed (9/16" wrench)
5. Blade diamond arbor knock out (wedge
feature)
Storage is provided on the tool (Fig. 1A).
Wrench is fully seated when second lock detent
is engaged.
Wrench
C UTION
inserted with the correct
orientation (Fig. 9). Damage to work piece
could occur if inserted incorrectly.
1/2" WRENCH
9/16" WRENCH
needs to
WEDGE
FE TURE
SLOTTED
DRIVER
CORRECT
depth of cut is reached then raise the set
screw until it just engages the motor housing
(Fig 7).
FIG. 7
SET SCREW
1
3
be
FIG. 9
-11-
FIG. 8
2
4
5
INCORRECT