Makita 6935FD Instruction Manual page 7

1 2
001267
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
1 2
004347
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
005941
Installing and removing hook
A) Removal
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
1. Bit
2. Sleeve
1. Bit
2. Bit-piece
3. Sleeve
3
Expand an far end of the hook outward and slide it down
while expanding.
005942
Expand the other far end in the same manner.
005943
Keeping the hook in this position, rotate down to the
angle 90°and remove it by pulling in the direction of
arrow as shown in the figure.
N m
High tensile bolt
(ft lbs)
1000
(740)
800
(590)
600
(440)
400
(300)
200
(150)
0 1 2
Fastening time(S)
005976
7
M24(1")
M24
(1")
M22(7/8")
M22
(7/8")
3 4 5