Yasuhiko Kanzaki CE 2005 compatible recycling facility. Intended use The tool is intended for screw driving in wood, metal and Director plastic. MAKITA INTERNATIONAL EUROPE LTD. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND Responsible manufacturer: Makita Corporation Anjo Aichi Japan...
GENERAL SAFETY RULES GEA002-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.
the power tool. Power tools are dangerous in the type of battery pack may create a risk of fire when hands of untrained users. used with another battery pack. 20. Maintain power tools. Check for misalignment or 25. Use power tools only with specifically desig- binding of moving parts, breakage of parts and nated battery packs.
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE ENC004-1 (1) Do not touch the terminals with any con- Before using battery cartridge, read all instruc- tions and cautionary markings on (1) battery ductive material. charger, (2) battery, and (3) product using bat- (2) Avoid storing battery cartridge in a con- tery.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 004916 • Always switch off the tool before insertion or removal of the battery cartridge.
For other countries 006349 To install these types of bits, follow the procedure (1). A=17mm (Note) Makita bits are these types. B=14mm To install these types of bits, follow the procedure (2). A=12mm (Note) Bit-piece is necessary for installing the bit.
Hook The hook is convenient for temporarily hanging the tool. This can be removed 005941 without using a tool. This can be installed on either side of the tool. Installing and removing hook A) Removal Remove the battery cartridge from the tool. Place the tool in a stable and level surface.
Keeping the hook in this position, rotate down to the angle 90° and remove it 005976 by pulling in the direction of arrow as shown in the figure. 005944 005945 B) Installation Remove the battery cartridge from the tool. Place the tool in a stable and level surface. Hold both hooking ends in the upper position and expand the upper part of the 005946 hook.
Insert both ends, one by one, of the hook into the grooves in the tool housing. 005947 1. Groove in the housing 005948 Keeping the hook in this position, rotate it upwards to the angle 90° and push 005949 both ends fully in the direction of arrow as shown in the figure. 005950 Storing the tool in the standard carrying case 005951...
When the hook is installed on the right side of the tool in back view, place the 005952 tool upside down with the hook facing up. OPERATION The proper fastening torque may differ depending upon the kind or size of the 004917 screw/bolt, the material of the workpiece to be fastened, etc.
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.