Hunter Pacific Typhoon Timber 42" Installation And Operating Instructions Manual

Please Note: The warranty form must be completed in full. All details are required and the form retained together with the
purchase receipt. Distributor and installer details are essential for on-site warranty claims and must be presented to repair
personnel.
WARNING – SEE FOLLOWING LIMITATIONS FOR CLAIMING ON-SITE WARRANTY
1. Fans and fixed wiring products must only be installed by persons who are appropriately licensed by the applicable State
regulatory body. Therefore, to protect our repair personnel, on-site warranty claims will not be accepted if products have
been installed by unlicensed persons.
2. Product not installed by appropriate personnel or not in accordance with instructions must be removed and returned to Hunter
Pacific International's service department at the owner's expense. The product will then be repaired or replaced at the
discretion of Hunter Pacific International and returned with shipping paid by Hunter Pacific International.
responsible for reinstallation charges.
3. Damage caused by incorrect installation, force-majeure, electrical surges, lightning, power grid fluctuations, water or by
connection to alternative power supply sources (such as solar inverters, etc.) is not eligible for warranty repair.
4. Blades must be replaced only as a complete set. Blades are supplied only as a pre-balanced set and the replacement of
individual blades may void the warranty by causing mechanical damage to the motor, excessive noise or premature wear.
5. When products are installed in a location requiring special access equipment (such as scaffolding or scissor lifts, etc) the cost
of providing, installing and operating special access equipment must be borne by the site owner. The need for, or use of,
such equipment must be stated when booking a service call. Charges will be levied for Hunter Pacific International to
arrange special access equipment and these must be paid in advance.
For safety, and to protect your warranty, the following must be taken into account when installing and operating the product(s):
(a) DO NOT USE SOLID-STATE WALL CONTROLLERS. Neither leading nor lagging edge controllers will give
satisfactory performance. Wall controls must only be types approved for use by Hunter Pacific International.
(b) The fan, light and bracket must be earthed.
(c) Fan and light must be run from the same phase and preferably the same final circuit.
(d) Mounting bracket must be firmly screwed to a solid structure such as a concrete ceiling, steel structure or timber
framing. If additional bracing is added it must be firmly secured to the rafters and not left floating on the ceiling.
Special mounts, such as T-hooks, are available for certain types of installation.
(e) After installation, fan blades must be at least 2.1 m (7 feet) above floor level.
(f) Supervise the use of these products by children and the infirm.
IF THERE ARE ANY PROBLEMS WITH THE PRODUCT AT TIME OF INSTALLATION THE
INSTALLER MUST CONTACT THE WARRANTY HOT LINE NUMBER BEFORE LEAVING
THE JOB SITE. PLEASE DO NOT REMOVE THE FAN FROM THE CEILING ONCE
IMPORTANT - PLEASE DO NOT PHONE THE RETAILER FOR WARRANTY
CLAIMS. INSTEAD PHONE 1300 360 280 FOR ALL WARRANTY ENQUIRIES
Hunter Pacific International Pty Limited (ABN 18 063 521 666), Building 8, 256 New Line Road, Dural NSW 2158 Australia
PLEASE READ AND KEEP THIS IMPORTANT
INSTALLED UNLESS INSTRUCTED TO DO SO.

WARRANTY INFORMATION

The owner is
1