Advertisement
Federal Communications Commission (FCC) notices
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the base of this equipment
is a label that contains, among other information, a product identifier
in the format US:AAAEQ##TXXXX. If requested, this number
must be provided to the telephone company.
Universal Service order Code (USOC): RJ11C
A plug and jack used to connect this equipment to the premises
wiring and telephone network must comply with the applicable FCC
Part 68 rules and requirements adopted by the ACTA. A compliant
telephone cord and modular plug is provided with this product. It is
designed to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
Ringer Equivalence Number (REN): 0.4
The REN is used to determine the number of devices that may be
connected to a telephone line. Excessive RENs on a telephone line
may result in the devices not ringing in response to an incoming call.
In most but not all areas, the sum of RENs should not exceed five
(5.0). To be certain of the number of devices that may be connected
to a line, as determined by the total RENs, contact the local
telephone company. For products approved after July 23, 2001,
the REN for this product is part of the product identifier that has
the format US:AAAEQ##TXXXX. The digits represented by ##
are the REN without a decimal point (e.g., 04 is a REN of 0.4). For
earlier products, the REN is separately shown on the label.
If this equipment (Telecom 400) causes harm to the telephone
network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance
notice isn't practical, the telephone company will notify the customer
as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone company
will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
24
This equipment (Telecom 400) contains no user servicable parts. If
trouble is experienced with this equipment (Telecom 400), for repair
or warranty information, please contact Tunstall Canada Inc. Tel
905-677-1144. If the equipment is causing harm to the telephone
network, the telephone company may request that you disconnect
the equipment until the problem is resolved.
Connection to party line service is subject to state tariffs. Contact
the state public utility commission, public service commission or
corporation commission for information.
If your home has specially wired alarm equipment connected to the
telephone line, ensure the installation of this equipment (Telecom
400) does not disable your alarm equipment. If you have questions
about what will disable alarm equipment, consult your telephone
company or a qualified installer.
When programming emergency numbers and (or) making test calls
to emergency numbers:
1. Remain on the line and briefly explain to the dispatcher the
reason for the call.
2. Perform such activities in the off-peak hours, such as early
morning or late evenings.
Alarm dialing equipment must be able to seize the telephone line
and place a call in an emergency situation. It must be able to do this
even if other equipment (telephone, answering system, computer
modem, etc.) already has the telephone line in use. To do so,
alarm dialing equipment must be connected to a properly installed
RJ31X jack that is electrically in series with and ahead of all other
equipment attached to the same telephone line. Proper installation
is depicted in the figure below. If you have any questions concerning
these instructions, you should consult your telephone company or
a qualified installer about installing the RJ31X jack and alarm dialing
equipment for you.
Hide quick links:
Advertisement
