Machine Operating Buttons - ELNA eXcellence 730 Instruction Manual

t
r
e
w
q
q
y
w
e
r
t

Machine Operating Buttons

q Start/stop button
Press this button to start or stop the machine.
The machine starts running slowly for the first few
stitches, it then runs at the speed set by the speed control
slider. The machine runs slowly as long as this button is
pressed.
The button will turn red when the machine is running, and
green when it has been stopped.
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
the button is released.
NOTES:
• The start/stop button cannot be used when the foot
control is connected to the machine.
• The machine will not run and the presser foot mark
y will blink if you start the presser foot in the up
position. Lower the presser foot and press the start/
stop button.
• You can select the desired start-up speed from
slow, medium or high (refer to page 27).
w Reverse button
When sewing stitch pattern 1, 4, 7, 8, 1S, 4S (mode 1), 01,
04, 07, 08, 12 (mode 2) or 01, 02, 03, 51, 52 (mode 3), the
machine will sew in reverse as long as the reverse button
is pressed.
If stitch pattern 1, 4, 7, 8, 1S, 4S (mode 1), 01, 04, 07,
08, 12 (mode 2) or 01, 02, 03, 51, 52 (mode 3), has
been selected and the foot control is not connected,
the machine will start sewing in reverse as long as the
reverse button is pressed.
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
e Auto-lock button
When sewing stitch pattern 1, 4, 7, 8, 1S, 4S (mode 1),
01, 04, 07, 08, 12 (mode 2) or 01, 02, 03, 51, 52 (mode 3),
the machine will immediately sew locking stitches and
automatically stop when the auto-lock button is pressed.
When sewing all other patterns, the machine will sew to
the end of the current pattern, sew locking stitches and
stop automatically.
The machine will trim the threads automatically after
locking the stitch when the auto thread cutting option is
turned on.
r Needle up/down button
Press this button to bring the needle bar up or down.
The machine will stop with the needle in down position.
However, you can change the needle stop position in the
setting mode (refer to page 27).
t Thread cutter button
Press this button when you finish sewing to trim the
threads. The needle bar automatically rises after trimming
the threads (refer to page 30).
NOTE:
Use the thread cutter on the face cover if the thread is
#30 or thicker (refer to page 30).
7