Table of Contents
Advertisement
R
e
p
l
R
e
p
l
The Process
1. Power off and unplug the heater. Allow at least 10 minutes for the bulbs to cool off.
2. Gently remove the glass panel from the heater "face."
3. Store the glass safely out of the way so that it does not get tripped on or damaged.
4. With assistance from a second person, carefully dismount and lower the heater to the floor, face up.
5. Towards the lower part of the heater's "face" there is a long, metal, rectangular cover, secured by three
Philip's head screws.
6. Remove the three screws and lift the cover up, and off (Ref. Fig 5).
7. Carefully bend the flexible tinsel bar towards you, while pulling and removing the left end of the bar from
the rubber grommet insert. Make sure the grommet stays in place and does not get lost (Ref. Fig 6 and 7).
*Lifting the loose end of the flexible bar should give you enough space for removing the bulbs.
8. Remove the defective bulb by unscrewing it counterclockwise (Ref. Fig 8).
9. Replace with a 40W E12 SES Clear Candle bulb, by screwing it clockwise.
*Make sure not to over-tighten the bulb, as it may cause damage to the bulb or the holder.
10. Reinstall the flexible tinsel bar by bending the bar towards you, while re-inserting into the grommet.
11. Make sure you "straighten" the flexible bar as much as possible (if you see bends) prior to re-installing the
metal cover.
12. Once the bulbs are replaced, re-install the metal cover with the 3 screws.
13. With assistance from a second person, re-mount the heater onto the wall and re-install the glass cover.
14. Your fireplace is now ready to be used (on the wall or on a flat surface depending on your mount option).
a
c
i
n
g
t
h
e
L
a
m
p
s
a
c
i
n
g
t
h
e
L
a
m
p
s
/
B
u
l
b
s
(
R
e
f
e
r
e
n
c
/
B
u
l
b
s
(
R
e
f
e
r
e
n
c
11
e
F
i
g
u
r
e
s
5
-
8
B
e
l
e
F
i
g
u
r
e
s
5
-
8
B
e
l
o
w
)
o
w
)
Hide quick links:
Advertisement
Table of Contents
