Precautions Before Replacing Lamps/Bulbs - lifeSMART INFRARED HEATER Owners Installation And User Manual

7. Align the base to a centralized position, in relation to the heater's underside (reference fig. 2).
 Note that only 4 long screws will be used to attach the base. There are no screw holes
missing on the base.
8. Make sure the base is flush to the heater's underside before securing, to avoid stripping screws.
9. Use four (4) long screws, (out of the 6 included in the wall mounting hardware kit
(reference fig. 3) to attach the base to the heater.
10. Make sure the screws are tight and that the base is very secure.
11. After installing the base, return the assembled fireplace to the vertical position and place it on a flat
surface with 3 feet of clearance all around the front, rear, and sides of the unit.
12. Finally, install the front glass panel. The device is ready to be used. Do not plug in the fireplace until
you have read the instructions completely.
Fig 1
This next section outlines the replacing of bulbs for the flame effect on your heater. To
prevent any accidents (or setup/assembly) miscues, please read and understand all
precautions prior to start. This ensures your safety and that all minimum mounting
requirements are met.

Precautions Before Replacing Lamps/Bulbs

 Warning-Always disconnect the heater from the power outlet before replacing bulbs.
 Warning-The bulbs reach high temperatures during operation. Allow the bulbs to
cool completely after powering the heater down, but before the replacement process,
to avoid mishaps.
 Note: Two people will be required for this process (if mounting or dismounting from
the wall).
 Note: It is recommended that the heater be set on the floor, on its back (face up), in
order to replace the bulbs.
Fig 2
10
Fig 3