Programming The Heating; Programming The Departure Time; Activation-Deactivation; Switching Off The Heating - CITROËN C5 Owner's Handbook Manual

Programming the heating

You must programme your depar-
ture time in order for the system to
calculate the optimum heater start
time automatically.
III

Programming the departure time

Press the buttons 1 to display the
programming time.
This symbol is displayed.
Once the programming time has
been displayed, press buttons 4 and
5 simultaneously within 10 seconds.
This symbol fl ashes.
Set the time by pressing the buttons 1
and press buttons 4 and 5 simultane-
ously to save it.
This symbol is displayed (fi xed).
58
C O M F O R T
Activation - deactivation
Once the programming time has
been displayed by means of the but-
tons 1 , press button 5 (ON) until the
message "OK" appears.
When the signal has been received,
the message "OK" is displayed
along with the symbol "HTM" .
This symbol is
when the heater starts.
HTM: Heat Thermo Management.
To deactivate the programming,
press button 4 (OFF) until the mes-
sage "OK" appears.
The symbol "HTM" is switched
off.
When carrying out these opera-
tions, if the message "FAIL" ap-
pears, the signal has not been
received. Repeat the procedure
after changing your location.

Switching off the heating

Press button 5 (ON).
The symbol "HTM" remains
on.
Changing the level of heating
The system offers 5 levels of heat-
ing (from the lowest level C1 to the
displayed
highest level C5 ).
Once the level of heating has been
displayed by means of the buttons 1 ,
press buttons 4 and 5 simultane-
ously.
The letter "C" fl ashes.
Set the level of heating by pressing
the buttons 1 .
Press buttons 4 and 5 simultane-
ously to save the level selected. The
letter "C" is displayed (fi xed).
The factory pre-sets are replaced
by the new settings entered. The
programmed times are stored until
the next time they are changed.
When the departure time is acti-
vated, the level of heating cannot
be changed. The departure time
must be deactivated fi rst.