Installation Considerations - Rockford Fosgate Fanatic P FNP2401x Operation & Installation

I
NSTALLATION
Tools Needed
The following is a list of some of the tools necessary for the installation of your
speakers.
Power Drill with assorted bits
Tape Measure
General
1. For safety, disconnect the negative lead from the battery prior to beginning
the installation.
2. Never run wires underneath the vehicle. Running the wires inside the vehicle
provides the best protection.
3. Avoid running wires over or through sharp edges. Use rubber or plastic
grommets to protect any wires routed through metal.
4. Mount the speakers/crossovers away from electrical sources (other than the
amplifier), i.e., power cables, electronic fuel pumps, vehicle computers,
and other potential noise sources.
5. Mount the speakers/crossovers away from areas of extreme heat or
moisture.
Tweeters
1. When mounting the tweeter(s) in the door of a vehicle, make sure they do
not interfere with either the door or window operation.
2. Please refer to the Specifications section of this manual for proper
mounting diameter and depth of the tweeters.
Crossovers
1. Make sure there is a flat area large enough for the crossover to mount.
2. For best results, mount the crossover(s) next to the amplifier for a decorative
finish to the installation and to provide an easy upgrade (no new wires to
run) for a bi-amp Rockford Fosgate system in the future.
C
ONSIDERATIONS
– 2 –
#2 Phillips Screwdriver
Voltmeter