AdvAnced OperAtiOn
Groups
Use a Miro Wireless DRD3 Switch in conjunction with one or more Miro Wireless
DRD8 Multilocation Controllers to control one non-dimmable lighting circuit
from multiple locations. Binding the DRD3 and DRD8 devices together in the
same Group enables them to work in exactly the same way, from any control
location.
You can include other Wireless Miro devices in the Group. Just remember that all
devices in the Group operate when one member operates.
Set the House ID (see Set House ID) before setting up Groups.
1. Go to any device that you want to include in the Group. Press
LED flashes yellow, and all other devices in the House flash green.
You now have 5 minutes to complete this process.
2. To include or exclude a device in the Group press
LED changes color. Yellow flashing LED = Included in the Group
If you get to a device and it is NOT flashing, the 5 minute binding process timer
may have expired. Go back to step 1 and repeat.
3. Return to the device used in step 1 and press
All LEDs turn solid green.
Adding a Switch to a Group in an existing System
1. Go to a device that is in the existing Group where you want to add the switch.
Press
. The device LED and all members of the Group flash yellow. The new
switch flashes green.
2. Press
on the new switch until its LED flashes yellow.
3. Return to the device used in step 1 and press
deleting a Switch from a Group in an existing System
1. Go to a device other than the one you're deleting that is in the existing Group.
Press
until the LED flashes yellow on each member of the Group.
2. Press
on the switch you want to remove, until its LED flashes green.
3. Return to the device used in step 1 and press
Green flashing LED = NOT included in the Group
. The device
on the device until the
to terminate Group binding.
. All LEDs turn solid green.
. All LEDs turn solid green.