Installing The Snap On Covers
1.
2.
ON
OFF
AUTO
Housing
Snap On Cover
(Shroud)
1 Pewter, 1 Shale
Place the pod on a soft surface to avoid damaging the plastic.
Installing The Shroud
Remove
tape backing
before installing.
(A)
Begin by hooking area "A" (above) over the dome light and slide the cover over the pod. The cover will snap in place.
Installing The Screen Cover
(B)
Open the screen and hook the two tabs "B" on the bottom edge of the screen. Snap the opposite side over the hinge.
Installing The Screw Cap & USB Cover
Plug-in
Screw cap & USB cover get installed after the unit is mounted.
3.
4.
Snap On Cover
Pry Tool
(Screen Back Cab)
1 Pewter, 1 Shale
catch
(B)
4
5.
6.
Screw Cap
USB Cover
(L & R)
2 Pewter, 2 Shale
catch
Plug-in